Provides fast and economical tube removal. It’s designed to remove tubes up to 25,4 mm(1”) O.D. in heat exchangers and condensers. In order to be easier removed, the tubes must be cutted previously. For operation comfort the tool may be holded in a balancer.  

In order to select correct components specify the thrust collar and the pulling spear by the tube O.D.

Tool used in conjunction and after the tube Wall Reduction Drill, to remove  tubes from tube sheets.

The hydraulic device consists basically of the hydraulic pump, tube puller and accessories. It’s capacity is to pull tubes up to 25,4mm (1”) O.D. Maximum stroke: 200mm Electrical motor: 110V x 60Hz, Insulation IP55 Select the pulling spear accordingly to the tube O.D.

For cutting carbon steel and non- ferrous tubes in heat exchangers and condenser… The tool is manually driven and cuts the tube in one revolution. As the tool is inserted into the tube and rotates clockwise, the knife projects outward. After the tube is cutted, rotates the tool counter-clockwise to retract the knife. This tool […]