The hydraulic device consists basically of the hydraulic pump, tube puller and accessories. It’s capacity is to pull tubes up to 25,4mm (1”) O.D. Maximum stroke: 200mm Electrical motor: 110V x 60Hz, Insulation IP55 Select the pulling spear accordingly to the tube O.D.

For cutting carbon steel and non- ferrous tubes in heat exchangers and condenser… The tool is manually driven and cuts the tube in one revolution. As the tool is inserted into the tube and rotates clockwise, the knife projects outward. After the tube is cutted, rotates the tool counter-clockwise to retract the knife. This tool […]

Tool used for reducing the tube wall thickness to facilitate removal of the tube from sheet.  

Suitable for flaring tube ends from 12,7 mm (½”) up to 38,1mm (1. 1/2”) O.D. With 60º included angle. For hand use or with chipping hammer.

Recessing Heads are used on several kinds of machine tools to perform grooves in heat exchangers and boilers tube sheet holes. These grooves grant better toughness and leakage proof to the tube/sheet expanded joint, The Recessing Heads have a wide range diameter application. Two head sizes can cover the range from 10 to 100 mm […]